View Neutra Reverb user manual, PDF
Tank effects
Process the sound inside the reverb loop with four effect slots.
Document revision 3 · Updated 17 November 2026
For product version 1.0.5
Start with the algorithmic reverb setup, then open Tank FX in Advanced. Choose Serial to run the slots in sequence or Parallel to combine their paths. Select a Slot, choose its Effect, and set Mix. The remaining controls change with the selected effect.
| Effect | Controls | Result |
|---|---|---|
| Filter | Cutoff, Resonance, Shape | Sweep between low-pass, band-pass, and high-pass filtering. |
| Erosion | Amount, Tone, Hold | Add noise that follows the tail; Hold coarsens it. |
| Saturator | Drive, Tone, Bias | Apply soft saturation to the tail; Bias adds even harmonics. |
| Modulation | Rate, Depth, Offset | Add a moving short-delay voice. |
| Pitch Shift | Shift, Window | Move the pitch up to an octave either way on every pass round the loop. |
| Diffusion | Amount, Size, Motion | Spread the tail in time with all-pass filters. |
| Gate | Threshold, Release, Hold | Close the loop below Threshold; Hold keeps it open briefly after the signal falls. |
| Comp | Threshold, Ratio, Release | Reduce tail peaks above Threshold by the Ratio. |
Page updated 2026-11-17