View Neutra Limiter user manual, PDF

Neutra Limiter

Interface

Locate the main controls in a numbered diagram.

Document revision 1 · Updated 23 October 2026

For product version 1.0.0

Neutra Limiter interface, with numbered callouts for the header, toolbar, graph, controls, Meters drawer, and Settings.

1. Header

The preset bar sits in the centre. Its left icons are Initialize and Save. See Presets. The power button next to it is Bypass. The number beside the power button is the plug-in latency in samples. See Latency and bypass. Gain In and Gain Out are small knobs for Input Gain and Output Gain.

2. Toolbar

A, B, Copy, Undo, and Redo are covered in Presets. The Style menu selects one of the nine styles. On the right, the True peak switch turns true peak limiting on and off, and the Oversampling menu is explained in Ceiling and output.

3. Graph

The graph scrolls from right to left and covers the last ten seconds. The grey line is the input, the blue line is the output, and the orange area is gain reduction. A legend above the graph shows or hides each trace when you click it. With the drawer closed, the top right shows the current gain reduction.

The strip on the left edge is Input Gain. Drag its tab up to push the signal harder into the limiter. The marker on the right edge, labelled THR, is Threshold. Double-click either control to reset it, and right-click or press Enter to type a value.

4. Controls row

The row below the graph holds Knee, Attack, Release, Lookahead, Link Transient, Link Release, Warmth, and Dither. Drag a knob, double-click to reset it, or click its readout and type a value. See Styles for the style controls and Attack, release, and lookahead for Attack and Release.

5. Meters drawer

The Meters tab on the right edge opens the drawer. See Metering and channels.

6. Settings

The gear in the header opens Settings.

SectionOption
Interface sizeChanges the size in 50% steps, from 50% upward
Graph rangeFull shows +6 to -60 dB and is the default. Focus shows +3 to -18 dB, where limiting happens
PresetsStep with arrow keys
ModulationShow modulation, which adds the modulation panel
MetersLevel meters, Loudness meters
SurroundLimit LFE

Interface preferences are saved per user and loaded when an editor opens. Limit LFE is saved with the plug-in state in your project.

Page updated 2026-10-21