View Neutra Compressor user manual, PDF

Neutra Compressor

Transfer curve

Read the graphs and draw your own compression curve.

Document revision 3 · Updated 5 November 2026

For product version 1.0.0

The transfer graph with its drawing nodes, and the level history beside it.

Transfer graph

Input level runs left to right and output level bottom to top. The diagonal is unity, where output equals input. The curve is a steady-level reference based on the stored Threshold, with style and linked Drive offsets. A dot marks current input; the shaded area beneath grows with signal level.

When Gain Out or Auto gain adds level, a Gain after note shows the added amount. Drag the transfer graph’s THR handle or the history’s threshold line to change Threshold when the active law uses it and Auto threshold is off. Double-click either to reset Threshold. The value fields show stored Threshold. With Auto threshold on in Single mode, THR Auto marks automatic operation while the curve and markers retain the stored-threshold reference. See Compression for Auto threshold’s response.

Level history

The history graph covers the last 10 s. It shows Input, Output and gain reduction; the GR reading shows current reduction. With External input or a MIDI source, a Sidechain trace appears.

Draw

For Single-mode drawing, choose a style with the Draw switch, such as Clean. With Draw on, nodes edit the transfer curve, starting from the current response. Click to add a node, up to 12. Drag nodes to move them or lines to bend them. Double-click a node to remove it. Right-click a node or line for Smooth, Linear, Ease in, Ease out, Ease in-out, Hold / step or S-curve. Middle-click a node to place it on unity, or a line to straighten it.

Draw applies the edited curve directly. Your saved control values return when you turn Draw off. In Single mode, timing stays active with Clean, Upward, Opto, Vari-Mu, VCA and Fairchild. The other styles with Draw follow the drawn curve directly.

Controls that shape timing or output level stay active: Auto gain uses Threshold and Ratio, VCA uses both for its response, and FET uses Ratio for saturation. For a Glue-styled Multiband band, Release set to Auto uses Threshold for recovery. Single-mode Auto release in Clean and Upward also uses Threshold.

In Multiband, select a band and turn on Curve in the toolbar to display its transfer graph. Use Draw there to edit its curve, including with a Glue-styled band. See Multiband.

Page updated 2026-10-28