View Neutra Compressor user manual, PDF
Glue
A bus compressor with stepped timing.
Document revision 3 · Updated 5 November 2026
For product version 1.0.0

Using Glue
In Single mode, choose Glue from Style. If Draw is active, first select Clean and turn Draw off in the transfer graph. It detects filtered full-wave peaks and compresses with stepped attack, release and ratio selectors.
Controls
- Attack ms offers 0.01, 0.1, 0.3, 1, 3, 10 and 30 ms.
- Release s offers 0.1, 0.2, 0.4, 0.6, 0.8 and 1.2 s, and Auto, which chooses the recovery from the signal.
- Ratio offers 2:1, 4:1 and 10:1.
- Range limits the gain reduction from 0 to 80 dB. Turn it fully right, or type Full, for no limit.
- Makeup adds -24 to +36 dB after compression.
- Dry/wet blends the dry and compressed signals from 0 to 100%.
- Auto gain adjusts the output level.
- SC HPF filters low frequencies from the detector. The knob spans 20 Hz to 2 kHz and you can type up to 15 kHz. Turn it fully left for Off.
- Focus Hz and Focus gain place a bell in the detector. Focus Hz spans 30 Hz to 15 kHz and Focus gain -15 to +15 dB. Focus Q in Settings sets the bell width from 0.1 to 18.
- Pre-clipper, also in Settings, soft-clips the detector signal.
Page updated 2026-11-05