View Neutra EQ user manual, PDF

Neutra EQ

Bands and filters

Create bands, choose shapes and slopes, and route them.

Document revision 1 · Updated 23 October 2026

For product version 1.0.0

Working with bands

Five bell bands shape the response across the spectrum, with cuts around 80 Hz and 1 kHz and boosts around 260 Hz and 3.6 kHz.

The blue curve combines the active bands. This example uses broad boosts and cuts across the spectrum.

Click an empty point on the graph to add a band. Clicks near the left or bottom edge add a low cut, and clicks near the right or top edge add a high cut. Elsewhere, clicks at 100 Hz or lower add a low shelf, clicks at 10 kHz or higher add a high shelf, and all others add a bell. If you chose Double click in Settings, double-click instead. Drag a node to change its frequency and gain. Hold Shift to lock movement to one axis, or hold Ctrl or Alt for fine control. Scroll over a node to change its Q.

Press [ or ] to select the previous or next band, and Delete or Backspace to remove the selected band. Alt-click a node to bypass that band.

Band panel

Right-click a node to open its panel. Frequency accepts Hz, kHz, or a note name, so 440 Hz, 1.5k, and A4 all work. Gain sets the level for shapes that use it, and Q sets the width or resonance.

Duplicate copies the band into the next free slot. Copy and Paste move a band's settings between bands, including between Neutra EQ instances loaded in the same host process.

Filter shapes

Use the shape menu at the top of the panel. Filter shapes explains the available families and their controls.

Slope and combine

Slope offers 6, 12, 18, 24, 36, 48, 72, and 96 dB/oct, plus Brickwall. The row's label shows what Slope sets: Steepness on most shapes, Phase order on phase shapes, Sharpness on Comb and Reverb, and Incline strength on Flat Tilt.

Combine sets how the band joins the signal. Multiply applies the filter and Subtract removes the filtered signal from the input. On shapes that offer Add, it adds the filtered signal to the input.

Channel routing

Process channels sets a band to Stereo, Left, Right, Mid, or Side, so you can treat the center and sides of a mix separately.

Piano, solo, and remove

Click a piano key to tune and audition the selected band. Double-click a key to add and audition a band at that note. Auditioning turns on Solo for that band, and turning Solo off in the band panel brings back the full EQ.

Turn on Solo in the panel to hear only the region that band affects. Double-click a node to remove it, or middle-click it to set its gain to 0 dB. On a cut, notch, band-pass, or phase shape, middle-click turns the band into a flat Bell. The panel also has Bypass, Reset band, and Remove band.

Page updated 2026-10-21