View Neutra Limiter user manual, PDF

Neutra Limiter

Ceiling and output

How the ceiling, true peak limiting, oversampling, output gain, and dither work.

Document revision 1 · Updated 23 October 2026

For product version 1.0.0

The ceiling

Output Level sets the digital ceiling. With True Peak on, the effective ceiling is the lower of Output Level and True Peak Ceiling.

Set Output Level and True Peak Ceiling in your host's parameter list or with automation. True Peak Ceiling stays at or under Output Level, and lowering Output Level below it brings True Peak Ceiling down too.

A full ten-second history of limiting with Input Gain at +9 dB, Threshold at -12 dB, and Modern selected.

In this example, the grey input peaks rise above the threshold while the blue output stays below it. The orange trace shows reduction building on each louder passage and recovering between them.

True peak limiting

With any of the eight lookahead styles, turn on True peak in the toolbar to catch peaks that fall between samples. A second stage measures the limiter's own output and corrects the gain when a reconstructed peak nears the ceiling. It aims about 0.09 dB under the ceiling.

The Oversampling menu sets the main peak detector. Off measures sample peaks; 4x checks between samples. Higher settings use a longer interpolation filter and add latency. The separate True peak guard also checks the output when True peak is on. Parameters lists the choices and ranges for these controls.

Oversampling and True peak change the plug-in latency, as Latency and bypass explains. The Oversampling menu is active while True peak is on.

Output Gain

Output Gain trims the signal after limiting and the ceiling. A positive setting raises the output above the ceiling. Set it to 0 dB or below when the output must stay at or under the ceiling.

Dither

Dither adds TPDF dither at the output and places samples on the grid of the chosen depth. Channels processed by the limiter stay within the effective ceiling adjusted by Output Gain. See Metering and channels for the LFE. Choosing a dither depth reveals the Noise shaping menu.

Choose the depth for the word length you are preparing, such as 16 bit. The plug-in continues to send floating-point samples to the host, quantized to that grid.

Noise Shaping changes the distribution of quantization noise. None gives unshaped TPDF; Basic applies gentle shaping. Optimized and High use stronger curves that move more noise toward high frequencies. Compare them at your chosen depth and sample rate when selecting the noise character.

Page updated 2026-10-21