View Neutra Reverb user manual, PDF

Neutra Reverb

Modulation

Create sources and route them to reverb controls.

Document revision 3 · Updated 17 November 2026

For product version 1.0.5

Enable Modulation in the toolbar to open the source dock at the bottom of the window. Select a source to show its controls there.

Add and assign

Add source + opens a new LFO. Change Type to choose another source.

In Target & Behavior, Add target chooses a destination. Depth sets the amount and direction, Offset shifts it, Range limits its output, and Smoothing softens changes. Or drag the source onto a control's modulation ring.

The source card's power button bypasses it while keeping its routes. To remove a route, select its target, then the x beside Add target.

Shape the source

  • LFO: choose Wave, Rate, and Phase. Unipolar moves from zero in one direction.
  • Envelope: Trigger offers Note for MIDI, Transport for playback, Level for input level, or continuous Loop. The Loop switch repeats while the trigger stays open.
  • Random: choose Hold, Walk, or Loop; set Rate and, for Loop, Loop steps.
  • Steps: set Step count and Rate, then drag each bar's level. Restart starts the pattern with playback.
  • Main follower: Attack and Release set response speed; Boost sets sensitivity. MIDI velocity and MIDI note follow incoming notes.

Sync selects musical Rate divisions for LFO, Envelope, Random, and Steps.

For an audio-triggered swell, choose Envelope and Trigger > Level, with Sync on. Set Threshold so the passage opens the gate, add Mix as a target with positive Depth, and choose Rate to fit the phrase.

In LFO Waveform or Envelope, click to add nodes, drag to move them, and double-click interior nodes to remove them. Drag lines to bend them; right-click for curve styles. Middle-click centres a node and straightens its adjoining lines, or straightens a line.

Page updated 2026-11-16