View Neutra EQ user manual, PDF

Neutra EQ

Modulation

Move EQ controls with LFOs, envelopes, followers, and MIDI.

Document revision 1 · Updated 23 October 2026

For product version 1.0.0

Turn on Show modulation in Settings to display the modulation bar under the graph. Hiding the bar leaves routes running.

Sources

Select + to add a source, and use its menu to change the type.

  • LFO: a repeating waveform with Rate and Phase controls and an editable waveform.
  • Envelope: plays a shape you draw each time its gate opens. Its Trigger can be Note, Transport, Level, or Loop.
  • Random: a changing random signal.
  • Steps: a repeating stepped pattern.
  • Main follower (shown as Input follower on its chip): tracks the level of the main input.
  • Sidechain follower: tracks the sidechain input.
  • MIDI velocity and MIDI note: follow the latest note-on event. Route MIDI to Neutra EQ in your host.

Editing a source

Select its chip to open the source editor. For an LFO, set Rate in Hz, or enable Sync and choose a musical division. Phase sets the starting position. Unipolar makes the waveform move in one direction from zero.

Click the waveform to add a node, drag nodes to move them, or drag a segment to bend it. Double-click an interior node to remove it. Right-click a node or segment for curve choices; middle-click flattens it. Envelope uses the same drawing gestures. In Steps, drag each bar to set its level and choose the step count and Rate.

Follower Attack and Release set how quickly the source rises and falls. Boost adjusts its sensitivity in dB.

Targets

A route controls one continuous parameter. For each band, the targets are Frequency, Gain, Q, Dynamic threshold, Dynamic range, Dynamic attack, Dynamic release, and Pitch glide. The global targets are Gain In, Gain Out, Pan, and Gain Scale.

Routes

Drag a source chip onto a control to create a route, or pick the control from the Target menu. Each route has these settings:

  • Depth: amount and direction, from -100% to +100%.
  • Offset: shifts the route, from -100% to +100%.
  • Range: the lowest and highest points the route can reach, each from -100% to +100%.
  • Smoothing: how quickly the route follows changes.

Modulated knobs indicate the live position, while numeric readouts show the stored setting. A ring around each knob shows the range the route can reach. To remove routes, use the x beside a target, right-click a control, or use the ... menu to clear everything.

Percentages describe travel through the target parameter's range, added to its stored setting. Removing a band clears its routes.

Pause and bypass

Pause holds the current modulation positions; Resume continues them. A source's power button removes its contribution, with the routes kept for when you enable it again.

Page updated 2026-10-21