View Neutra EQ user manual, PDF
Dynamic EQ and pitch
Make a band react to the signal, or follow the pitch of the music.
Document revision 1 · Updated 23 October 2026
For product version 1.0.0
Open a band and select Dynamic / Pitch.
Dynamic EQ
Turn on Dynamic EQ to make the band respond to its detector. Dynamic EQ works on shapes that use Gain.
- Threshold: the detector level where the change begins.
- Range: the largest gain change in dB. Negative values cut and positive values boost.
- Attack and Release: how quickly the band responds, in milliseconds.

Here, the detector is above the -24 dB threshold and the band applies 1.1 dB of additional reduction. Range sets how far that reduction can go.
The detector meter shows the level and marks the threshold. Drag the marker or type a value to set it. With Auto threshold on, the marker follows the automatic threshold.
For conventional Dynamic EQ, the detector hears the band's frequency region. Low and high shelves detect their respective low and high regions; other gain shapes use Frequency and Q to focus detection around the band. Sidechain uses the same filtering on the external input and falls back to the main input when that connection is empty. In the host's parameter list, Dynamic Trigger set to Free selects full-band detection.

Detector and spectral options
Open Detector and spectral options for these controls:
- Auto threshold: the threshold follows the long-term level of the signal.
- Sidechain: conventional Dynamic EQ listens to the sidechain input of your host.
For spectral dynamics, use these two:
- Spectral density: lets frequencies inside the band react independently. Choose Off, Low, Medium, or High. Higher settings are more selective.
- Tilt: weights detection by 3 dB per octave.
Spectral dynamics measure the main input at each frequency and apply reduction or boost independently across the band. They run in Linear phase or Hybrid phase. Choosing a density turns on Dynamic EQ, and in Zero latency or Natural phase it also switches the mode to Linear phase.
Pitch following
Pitch following is most effective on a single sound source, such as a voice, bass, or solo instrument. Use it on individual parts that have a clear pitch to follow.
Turn on Follow pitch for a band, open Pitch detection, and use Follow to choose which harmonic of the detected note the band sits on: Auto, or Harmonic 1 to 16. With Auto, the band locks to the harmonic nearest its position when the first note arrives. A band placed below three quarters of the first note keeps its frequency ratio to the note and moves in proportion as the pitch changes. Glide sets how quickly the band moves, in milliseconds. One detector serves every band, so the Pitch detection settings are shared:
- Threshold: the input level that counts as pitched.
- MIDI note: follow MIDI notes. Note Sets Pitch follows a held note, and While Note Held follows the audio pitch while you hold a note.
- Lookahead: Off, 10, 25, 50, or 100 ms. It delays the audio so bands act ahead of it.
- Attack and Release: gate times for the detector.
Page updated 2026-10-21