View Neutra Limiter user manual, PDF

Neutra Limiter

Modulation

Move controls automatically with LFOs, envelopes, followers, and MIDI.

Document revision 1 · Updated 23 October 2026

For product version 1.0.0

Turn on Show modulation in Settings. A modulation panel appears with a source bar and route controls.

Sources

Click + to add an LFO, then use its Type menu to choose the source you want: LFO, Envelope, Random, Steps, Main follower, Sidechain follower, MIDI velocity, and MIDI note. The Sidechain follower reads the stereo sidechain input. MIDI sources respond to the note and velocity data your host sends to the plug-in.

Source controls

Select a source to edit it. LFO Rate sets cycles per second; Sync changes Rate to musical divisions. Phase moves the starting point, and Unipolar makes its output run from zero in one direction.

Draw an LFO or Envelope shape by clicking to add nodes and dragging to position them. Drag a line to bend it, right-click for curve types, double-click an interior node to delete it, or middle-click to flatten. Envelope plays its shape when the selected Note, Transport, Level, or Loop gate opens. Steps repeats its pattern after the Step count. Drag each step bar to set its level, and use Rate to set the pace.

Main follower and Sidechain follower turn signal level into modulation. Their Attack and Release control response time, and Boost changes sensitivity.

Targets and routes

You can modulate ten continuous controls: Input Gain, Threshold, Knee, Output Level, True Peak Ceiling, Attack, Release, Ch. Link Transient, Ch. Link Release, and Output Gain.

Drag a source onto a knob, or pick any of the ten controls from the Target menu, to add a route. Output Level and True Peak Ceiling are reached through the Target menu. Each route adds an offset to the control's value, and you can set its depth and smoothing. Modulation overlays show the assigned range on visible target controls, and knob arcs show the current modulation position. Select a source in the source bar, then choose its target from the Target menu to edit the route.

Depth sets the amount and direction. Offset shifts it, Range sets its lower and upper bounds, and Smoothing softens changes. Percentages refer to travel across the parameter's range relative to its saved value. The x beside Target deletes that route.

Holding or stopping movement

Use Pause to hold the current offsets and Resume to continue movement. Turn off a source with its power button to remove its contribution while keeping its routes.

See Presets for saving and comparing modulation setups.

Page updated 2026-10-21