View Neutra Reverb user manual, PDF

Neutra Reverb

Curve editing

Add points, change their shape, and bend response lines directly.

Document revision 3 · Updated 17 November 2026

For product version 1.0.5

Add and select points

In Advanced, choose EQ and a frequency tab. New graphs start empty. Click to add a point; drag horizontally for frequency and vertically for value. Hold Ctrl or Alt for finer movement; hold Shift to lock movement to the first axis you drag along. Choose Single click or Double click creation under Settings > EQ GRAPH > Add band.

Preparing Decay EQ means the current filters play until the new response is ready.

Click to select a point; use [ or ] to select its neighbours. Delete, Backspace, or double-click removes it. Middle-click flattens its response. Alt-click toggles bypass on an added point.

Wheel over a point to change Q. Click a readout to type a numeric value.

Filter panel

Right-click a point and choose Filter. Choose its shape beside the band number. Below are Frequency, Q, and Rate, Gain, Width, Balance, Delay, or Depth for the selected graph. The panel's Frequency field accepts 1k, 440 Hz, or A4.

Filter panel for a Bell point at 350 Hz and a decay rate of 110%.

For a Bell, higher Q narrows a boost or cut; lower Q broadens it. Q controls cut resonance or shelf transition. The slope row controls Steepness in dB/oct, phase order, ringing sharpness, or tilt strength for the chosen shape.

Combine chooses how the band uses its input and filtered signal. Multiplicative uses the filtered signal; Subtractive subtracts it from the band's input. Shapes offering Additive add the two signals.

Process channels selects Stereo, L, R, M, or S. Use Bypass to switch the filter in and out, and Solo to audition it. Band actions: Reset band, Remove band, Duplicate, Copy, Paste.

Dynamic EQ and pitch

Open Dynamic / Pitch in a point's panel; for Reverse sounds, use Early/Late. Enable Dynamic EQ for a response that follows signal level. Threshold sets detector level and Dynamic Range its amount and direction. Attack and Release set onset and recovery. Detector options holds Ratio, Knee, and more detector controls. GR shows current dynamic gain change.

Follow pitch moves frequency with the detected note; Glide smooths the movement. Pitch detection sets tracking range, harmonic, and detector controls. Use a single voice or instrument for steadier tracking. In Early/Late, Meter branch selects Early or Late detector and GR readings.

Dynamic and pitch controls for a Decay point, with timing shown in milliseconds.

Response lines and piano

Hover between points until a small circle appears. Drag vertically to bend the response, or right-click for the associated point's panel. Undo and Redo include graph edits.

Use the keyboard button at the lower left of the EQ graph to show the piano. The range selector at the upper right changes the vertical view; Auto fits the response.

See Frequency curves for each graph's purpose and Graph and band parameters for ranges.

Page updated 2026-11-16